Advice for upgrading my VW head unit3450350

Bookmark and find a surprise

From How to learn a language
Jump to: navigation, search

So you have got your amplifier, subwoofer, speakers and head unit for the Volkswagen. Now what? Installing a stereo in a car usually is not as daunting a challenge as it appears at first with those wires. On The Other-hand, some suggestions may help when approaching the job for the.

Whenever working on electrical devices, ensure everything is turned off to stop hurting yourself. Pop the hood and disconnect the battery. Make sure you've properly disconnected it by examining your dashboard.

Cleanly installing a stereo for the car is usually the trickiest & most timeconsuming sections of the setup procedure due to many wires running to the head and amplifier device. Before starting, be certain you understand the solution to wire your amp, speakers and head unit because that info can actually save a real pain afterward.

The baggage compartment is the most logical area to situate the amp. The amp will undoubtedly be screwed by lots of people towards the back of the rear-seat to save space or simply screw it towards the base of the trunk. Either way works good.

The entire back seat folds down, creating a straightforward avenue to run wires through to the front part of the auto. It is also where you'll have to ground your amplifier. Seem underneath the bottom seat cushions in the back, you'll see the seatbelts are screwed in with a nut. Use a Phillips-head screw-driver to engage the grounding cable and unscrew the nut, then twist everything back together.

Open one of the back-doors and furthermore you'll see a plastic panel to the earth. This is the place where you'll have to remain on wiring your stereo. The same holds true for your frontdoor. These blackplastic panels may be removed by unscrewing the screws with a Phillips head screw driver. After running the wires beneath these panels, you'll arrive at the very front section of the car and an apparent dead-end. However, additionally for the trunk, the carpeting could be pulled back to keep on hiding the wires. You shouldn't be concerned about if you just pullout the fringe sections of the carpeting destroying the rug as it's readily re attached.

From here, you can apply all of the needed wires up to the head unit. First, remove the head unit in the dash. Some people will further eliminate parts of the dash to make room to properly run cables to the top device. However, using a straightforward trick can become a time saver. Use a broken coathanger to run wires up through the wiring channel supporting the head unit. Considerable time may be saved by this.

Locate a gap in the vehicle to run the electricity cable from your amplifier to the battery.

Detailed info on VW Autoboxen can be found on the main website.

Personal tools